[c-nsp] Policing switch ports on 1811

[The Father]

No responses so far?

Jose

The Father wrote:
> Hi everyone.  I'm trying to find a way to rate-limit or police to 3Mbps 
> two of the switch ports on an 1811 router.  I have configured both FE 
> ports as follows:
>
> interface FastEthernet2
> switchport access vlan 10
> load-interval 30
> !
> interface FastEthernet9
> switchport access vlan 10
> load-interval 30
>
> Now since these are basically layer 2 ports, I can't come up with a 
> policy map or ACL to police them down to the 3Mbps value I want.  
> Everything I try does not get matched.  The router doesn't seem to 
> support aggregate policing either so I'm kinda stuck.  Are there any 
> other options that would work?
>
> FYI, I'm running 12.4(6)T7 Advanced IP Services code.
>
> Thanks.
>
> Jose
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
>
>