[c-nsp] Show system jumbomtu

[Alaerte.Vidali at nokia.com]

Thank you.

Would you indicate good documentation public available that explains if
when using system MTU it is still necessary use interface MTU?
(or not)

And shows the relation between:
Vlan MTU
System MTU
MPLS MTU
Interface MTU

I read documents I found in Cisco page, and applied it on 7600. The
result I got is that only system MTU was not enough. It was necessary
configure interface MTU.


Regards,
Alaerte  

-----Original Message-----
From: ext Sukumar Subburayan [mailto:sukumars at cisco.com] 
Sent: Friday, March 30, 2007 3:27 PM
To: Vidali Alaerte (Nokia-NET/RioDeJaneiro)
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] Show system jumbomtu

We had supported 'show system mtu' cli only on the cat4k.

On the 6k, since the configured system MTU can be viewed in the running
config, it command to show the value was not added.

we never got to implement 'show system jumbomtu'.

Please refer to CSCdy28580

sukumar




On Fri, 30 Mar 2007, Alaerte.Vidali at nokia.com wrote:

> Do you know if there is any hidden issue with this command?
>
> I tried it in 2 IOS versions it was supposed to work, but no support.
>
> Version 12.2(33)SRA1
>
> OSR-1#show system ?
> % Unrecognized command
> OSR-1#show system
>
> Version 12.2(17d)SXB7
> OSR-2#sh system?
> % Unrecognized command
> OSR-2#sh system
>
>
>
> Tks,
> Alaerte
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net 
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>