[c-nsp] SNMP Objects for total mac address and total vlans in use

[Peter Rathlev]

On Thu, 2007-11-22 at 23:16 +0100, Peter Rathlev wrote:
> Something like:
> 
> ip rcmd rsh-enable
> ip rcmd remote-host <RSHUSER> <host ip> <RSHUSER> enable
> 
> in the config means that you can do a "rsh <switch ip> show vlan summ \|
> incl existing VLANs" from your host as the RSHUSER user.

I'll correct myself a little here. If you just need the two described
commands, there's no need to use the "enable" keyword at the end of the
rcmd remote-host definition. Leave it out unless needed. :-)

Regards,
Peter Rathlev