[c-nsp] 4 port ISE Giga CARD problem

[Plz]

Hi, Guys.
   A new card(4 port ISE gigaethernet) couldn't go online, everytime stopped
at starting IOS.
   I tried reload the slot soft/hard, but it didn't work. Here is the diags.
   I didn't see the "memory part" in the diags so i think it's memory
problem, maybe on-site
   engineer didn't get it placed right.
   Any ideas will be appriceated.
-------------------------------------------------
xxxxxxxxxx#sh ver
Cisco Internetwork Operating System Software
IOS (tm) GS Software (GSR-P-M), Version 12.0(27)S5, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Mon 09-May-05 12:48 by kellythw
Image text-base: 0x50010C84, data-base: 0x532C8000
ROM: System Bootstrap, Version 11.2(20030116:225008)
[rarcher-pre_lci_throttle 184], DEVELOPMENT SOFTWARE
BOOTLDR: GS Software (GSR-BOOT-M), Version 12.0(8)S, EARLY DEPLOYMENT
RELEASE SOFTWARE (fc1)
xxxxxxxxx uptime is 3 hours, 5 minutes
System returned to ROM by reload
System restarted at 15:43:06 Beijing Thu Jun 26 2008
System image file is "slot0:gsr-p-mz.120-27.S5.bin"
cisco 12008/GRP (R5000) processor (revision 0x05) with 524288K bytes of
memory.
R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache
Last reset from power-on
2 Route Processor Cards
2 Clock Scheduler Cards
3 Switch Fabric Cards
2 Three Port Gigabit Ethernet/IEEE 802.3z controllers (6 GigabitEthernet).
1 Four Port Gigabit Ethernet/IEEE 802.3z controller (4 GigabitEthernet).
1 Ethernet/IEEE 802.3 interface(s)
10 GigabitEthernet/IEEE 802.3 interface(s)
507K bytes of non-volatile configuration memory.
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2102
WARNING: Old fab-loader in slot 4; use "upgrade fabric-downloader" to update
WARNING: Old MBus agent ROM in some slots; use "upgrade mbus-agent-rom" to
update
xxxxxxxx#sh diags 4
SLOT 4  (RP/LC 4 ): 4 Port ISE Gigabit Ethernet
  MAIN: type 119,  800-22811-07 rev F0
        Deviation: 0
        HW config: 0x00    SW key: 00-00-00
  PCA:  73-8517-07 rev C0 ver 5
        Design Release 6.0  S/N SAL113922D7
  MBUS: Embedded Agent
        Test hist: 0x00    RMA#: 00-00-00    RMA hist: 0x00
  DIAG: Test count: 0x00000000    Test results: 0x00000000
  FRU:  Linecard/Module: 4GE-SFP-LC=
  L3 Engine: 3 - ISE OC48 (2.5 Gbps)
  MBUS Agent Software version 1.98 (RAM) (ROM version is 2.32)
  ROM Monitor version 1.13
  Fabric Downloader version used 5.6 (ROM version is 6.4)
  Primary clock is CSC 1
  Board is analyzed
  Board State is Starting IOS (IOS  STRT)
  Insertion time: 00:46:49 (02:18:46 ago)



Best Regards,
        runt