[c-nsp] TelcoSystems EdgeGate 282 and Cisco 3560 10Full

[Brandon Bennett]

Auto-mdix is disabled when you hard code speed/duplex.   Check to make  
sure cable is a crossover

-Brandon

Sent from my iPhone

On Nov 20, 2008, at 6:56 PM, Christopher Hunt <chunt at reachone.com>  
wrote:

> I have a cisco 3560 switch connected to a TelcoSystems EdgeGate 282  
> CPE switch provided by a local FTTx provider.
> * Ethernet auto-negotiate works fine but,
> * when the CPE at is hard-coded at 10/Full, and the 3560 at auto- 
> auto, I get 10/Half on the 3560 (that's to be expected).
> * Auto-auto on both gets me 100/Full on both (also expected).
> * 10/Full on both gets me  nothing, link is down on both.
>
> We have put in a service case with Telco Systems to see if there is  
> something we can do about it.  Has anyone any experience with this  
> hardware?
>
> -- 
> Christopher Hunt
> ReachONE Internet, Inc.
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/