[c-nsp] cisco command to show 10GE module type?

[Nick Griffin]

can you use "show interface capabilities"?

On Fri, Apr 17, 2009 at 11:41 PM, Engelhard Labiro
<engel.labiro at gmail.com>wrote:

> Use command "show int status"
>
> Sent from my iPhone
>
>
> On 2009/04/18, at 11:04, Neil d <neilding2000 at gmail.com> wrote:
>
>  Hi all,
>>
>> Is there any command to show what kind of Xenpak 10G module in the
>> 6704-10GE
>> card? from cisco website, there're a bunch of them:
>>
>> Cisco XENPAK-10GB-CX4: .
>> • Cisco XENPAK-10GB-LX4:
>> • Cisco XENPAK-10GB-LRM:
>> • Cisco XENPAK-10GB-SR:
>> • Cisco XENPAK-10GB-LR / -LR+:
>> • Cisco XENPAK-10GB-ER / -ER+
>> • Cisco XENPAK-10GB-ZR:
>> • Cisco XENPAK-10GB-LW (WAN PHY):
>>
>> question is, how do I know which type is installed in the LC? any command
>> to
>> check this instead of going onsite to check?
>>
>> TIA/Neil
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>