[c-nsp] EoMPLS - port mode to vlan mode

[Saku Ytti]

On (2009-02-13 17:04 -0500), Laurent Geyer wrote:
 
> Still, you cannot define a networking type for a pseudo wire until
> mpls encapsulation is enabled.

I'm sorry if yo understood my connect that way, I was simply trying
to explain you don't specify it in the xconnect line, but instead
use pw-class where you can (also) define interworking.

> I just tested what you suggested and the output for `show mpls
> l2transport vc 821 detail' is the same whether I use a pseudo wire
> class like you suggested, or I simply define encapsulation mpls on the
> interface level.

Did you configure it on both sides? Configuration is OK now.

-- 
  ++ytti