[c-nsp] flash disk problem

[Church, Charles]

Does the Sup have Rommon 7.1(1) on it?  Otherwise, it won't understand the 64MB ATA card.  I believe that's the only one that shows up as disk0:.  The smaller ones aren't ATA, so they're linear and show up as slot0:.  Did you try verify slavedisk0:filename?

Chuck 

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Alex Wa
Sent: Wednesday, February 25, 2009 11:46 AM
To: lista de correo de cisco
Subject: [c-nsp] flash disk problem


Hi guys
 
I copied a file to slavedisk0: on a 6513-sup II board. when  I try to use verify slaveslot0:filename I get this error output
 
%Error verifying slaveslot0:c6sup22-jk2sv-mz.121-22.E2.bin (Bad file number)
 
the disk was formatted in this switch and the file copied  without problems. The issue is that i'm trying to upgrade the IOS to the new one in flash and it can't load. 
 
I also would like to know the difference between disk0: and slot0:, i don't fully understand it, if any.
 
thanks in advance
Alejandro 


      
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/