[c-nsp] NBAR support for 7600-SIP-400 ?

[Andy Saykao]

Does anyone know if NBAR is supported on the 7600-SIP-400 (4-subslot SPA
Interface Processor-400)? I've applied "ip nbar protocol-discovery" on
Gig4/0/2 but do not see any matches. This is a 7606 SUP32 running
12.2(33)SRB3.
 
interface GigabitEthernet4/0/2
 bandwidth 200000
 ip address 203.x.x.x 255.255.255.252
 ip nbar protocol-discovery
 load-interval 30
 negotiation auto
 mpls ip

#sh ip nbar protocol-discovery interface g4/0/2 top-n 1
 
 GigabitEthernet4/0/2
                            Input                    Output
                            -----                    ------
   Protocol                 Packet Count             Packet Count
                            Byte Count               Byte Count
                            30sec Bit Rate (bps)     30sec Bit Rate
(bps)
                            30sec Max Bit Rate (bps) 30sec Max Bit Rate
(bps)
   ------------------------ ------------------------
------------------------
   bgp                      0                        0
                            0                        0
                            0                        0
                            0                        0
   unknown                  0                        0
                            0                        0
                            0                        0
                            0                        0
   Total                    0                        0
                            0                        0
                            0                        0
                            0                        0

 
Googling around, I found a previous nsp post that said NBAR was only
available on the 7600-SIP-200 but this post is 3 years old.
 
"NBAR with Sup720 is only supported on FlexWAN, Enhanced FlexWAN, and
the 7600-SIP-200 modules"
 
Also read the data sheet on the 7600-SIP-400 and no mention of NBAR
support on there?
 
http://www.cisco.com/en/US/prod/collateral/routers/ps368/product_data_sh
eet0900aecd8027c9e6.html
 
Thanks.
 
Andy

This email and any files transmitted with it are confidential and intended
 solely for the use of the individual or entity to whom they are addressed. 
Please notify the sender immediately by email if you have received this 
email by mistake and delete this email from your system. Please note that
 any views or opinions presented in this email are solely those of the
 author and do not necessarily represent those of the organisation. 
Finally, the recipient should check this email and any attachments for 
the presence of viruses. The organisation accepts no liability for any 
damage caused by any virus transmitted by this email.