[c-nsp] Time for a new sup?

Randy McAnally rsm at fast-serv.com
Wed Dec 15 09:00:11 EST 2010


This came and went on a sup720 3bxl on SXI5.  It didn't fail over to slave and
didn't drop any traffic either...all lights are still green.  TCAM corruption?

3w1d: %CONST_DIAG-SP-3-HM_TEST_FAIL: Module 6 TestSPRPInbandPing consecutive
failure count:5
3w1d: %CONST_DIAG-SP-6-HM_TEST_INFO: CPU util(5sec): SP=19% RP=3% Traffic=0% 
netint_thr_active[0], Tx_Rate[6361], Rx_Rate[234], dev=4[IPv6, fail=5]
3w1d: %CONST_DIAG-SP-4-HM_TEST_WARNING: Sup switchover will occur after 10
consecutive failures
3w1d: %CONST_DIAG-SP-3-HM_TEST_FAIL: Module 6 TestSPRPInbandPing consecutive
failure count:10
3w1d: %CONST_DIAG-SP-6-HM_TEST_INFO: CPU util(5sec): SP=7% RP=1% Traffic=0%
netint_thr_active[0], Tx_Rate[5021], Rx_Rate[276], dev=4[IPv6, fail=10]
3w1d: %CONST_DIAG-SP-4-HM_TEST_WARNING: Sup switchover will occur after 10
consecutive failures
3w1d: %CONST_DIAG-SP-3-HM_TEST_FAIL: Module 6 TestSPRPInbandPing consecutive
failure count:15
3w1d: %CONST_DIAG-SP-6-HM_TEST_INFO: CPU util(5sec): SP=7% RP=2% Traffic=0%
netint_thr_active[0], Tx_Rate[4868], Rx_Rate[292], dev=4[IPv6, fail=15]
3w1d: %CONST_DIAG-SP-4-HM_TEST_WARNING: Sup switchover will occur after 10
consecutive failures
3w1d: %CONST_DIAG-SP-3-HM_TEST_FAIL: Module 6 TestSPRPInbandPing consecutive
failure count:20
3w1d: %CONST_DIAG-SP-6-HM_TEST_INFO: CPU util(5sec): SP=8% RP=1% Traffic=0%
netint_thr_active[0], Tx_Rate[5250], Rx_Rate[234], dev=4[IPv6, fail=20]
3w1d: %CONST_DIAG-SP-4-HM_TEST_WARNING: Sup switchover will occur after 10
consecutive failures
3w1d: %CONST_DIAG-SP-6-HM_TEST_RECOVERED: Module 6 TestSPRPInbandPing
recovered after 22 consecutive failure(s)

--
Randy M.




More information about the cisco-nsp mailing list