[c-nsp] MSC Cisco CRS-1

[nsp.lee]

RP/0/RP0/CPU0:XXX#show  license 
FeatureID: CRS-MSC-40G-IMP (Slot based, Implicit[Remaining time: unlimited])  
  Total licenses 3
  Available for use         0
  Allocated to location     0
  Active                    3
    Pool: Owner
      Total licenses in pool: 3
      Status: Available     0    Operational:    3 
      Locations with licenses: (Active/Allocated) [SDR]
              0/9/CPU0        (1/0) [Owner]
              0/8/CPU0        (1/0) [Owner]
              0/0/CPU0        (1/0) [Owner]



RP/0/RP0/CPU0:XXX#show diag  0/0/CPU0
CARD 0/0/* : Cisco CRS-1 Series Modular Services Card revision B
  MAIN:  board type 500063
         800-27067-06 rev A0
         dev N/A
         S/N SADXXXXXXXX
  PCA:   73-10334-06 rev A0
  PID:   CRS-MSC-B
  VID:   V04
  CLEI:  IPUCALFBAC
  ECI:   168422
PLIM 0/PL0/* : Cisco Carrier Routing System SPA Interface Processor Card
  MAIN:  board type 580070
         800-23819-06 rev C0
         dev N/A
         S/N SADXXXXXXXX
  PCA:   73-8982-08 rev C0
  PID:   CRS1-SIP-800
  VID:   V04
  CLEI:  COUIANKCAB
  ECI:   165066
  Interface port config:  0 Ports
  Optical reach type:  Unknown
  Connector type:  Unknown
NODE 0/0/CPU0 
  Node State : IOS XR RUN
  PLD:   Motherboard: 0x0015, Processor: 0x0015, Power: N/A
  MONLIB: QNXFFS Monlib Version 3.1
  ROMMON: Version 1.53(20090311:225342) [CRS-1 ROMMON]
  MEM Size: 2048 Mbytes


2011-02-11 



even.lee 



发件人： Alessandro Braga 
发送时间： 2011-02-11  23:36:14 
收件人： cisco-nsp 
抄送： 
主题： [c-nsp] MSC Cisco CRS-1 
 
Dear,
which the command can I use in IOS-XR (CRS-1) to obtain MSC details; eg
Performance (20G,40G, 140G).
The commands bellow don't show it:
show inventory
show version
I think that 'show diag ?' will show, I'm correct?
Brgs,
Alessandro Braga
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/