[c-nsp] Nexus N7K-M132XP-12 powerup

[Tim Stevenson]

Hi Renelson,

My first suspicion would be that these are in fact N7K-M132XP-12L 
cards (note the trailing "L"). The "L" version of this card is only 
supported from 5.1, I'd recommend 5.1(3).

Otherwise, I'd open a TAC case, as support for the non-L version is 
there from day 1.

Hope that helps,
Tim

At 01:39 PM 6/11/2011, Renelson Panosky pronounced:

>I am working on a N7K with two of the above cards.  they're showing power
>down and everytime i tried to power them back up i got the following
>errors.
>
>switch(config)# 2011 Jun 12 01:22:36 switch %$ VDC-1 %$
>%PLATFORM-2-PFM_MODULE_POWER_ON: Manual power-on of Module 7  from Command
>Line Interface
>2011 Jun 12 01:22:39 switch %$ VDC-1 %$
>%PLATFORM-2-MOD_PWRIDPROM_SW_CARD_ID_UNKNOWN: Module 7 failed to power up.
>(Unknown card. Could not get software-card-id)
>
>I am running Software version 5.0 (2a) and i moved one the card in slot 7
>and still getting the same error.
>
>
>  sho mod
>Mod  Ports  Module-Type                      Model              Status
>---  -----  -------------------------------- ------------------ ------------
>1    0      Unknown Module                                      powered-dn
>2    48     10/100/1000 Mbps Ethernet Module N7K-M148GT-11      ok
>3    48     10/100/1000 Mbps Ethernet Module N7K-M148GT-11      ok
>5    0      Supervisor module-1X             N7K-SUP1           active *
>6    0      Supervisor module-1X             N7K-SUP1           ha-standby
>7    0      Unknown Module                                      powered-dn
>Mod  Power-Status  Reason
>---  ------------  ---------------------------
>1    powered-dn     Unknown card (Could not get software-card-id)
>7    powered-dn     Unknown card (Could not get software-card-id)
>Mod  Sw              Hw
>---  --------------  ------
>2    5.0(2a)         1.7
>3    5.0(2a)         1.7
>5    5.0(2a)         1.8
>6    5.0(2a)         1.8
>
>Mod  MAC-Address(es)                         Serial-Num
>---  --------------------------------------  ----------
>2    50-3d-e5-b3-35-5c to 50-3d-e5-b3-35-90  JAF1502BDGH
>3    50-3d-e5-b9-81-a0 to 50-3d-e5-b9-81-d4  JAF1502BDGF
>5    10-8c-cf-1d-e5-d0 to 10-8c-cf-1d-e5-d8  JAF1453BKBK
>6    8c-b6-4f-e8-ee-60 to 8c-b6-4f-e8-ee-68  JAF1453BKCF
>Mod  Online Diag Status
>---  ------------------
>2    Pass
>3    Pass
>5    Pass
>6    Pass
>Xbar Ports  Module-Type                      Model              Status
>---  -----  -------------------------------- ------------------ ------------
>1    0      Fabric Module 1                  N7K-C7010-FAB-1    ok
>2    0      Fabric Module 1                  N7K-C7010-FAB-1    ok
>3    0      Fabric Module 1                  N7K-C7010-FAB-1    ok
>Xbar Sw              Hw
>---  --------------  ------
>1    NA              1.1
>2    NA              1.1
>3    NA              1.1
>
>Xbar MAC-Address(es)                         Serial-Num
>---  --------------------------------------  ----------
>1    NA                                      JAF1453BPHE
>2    NA                                      JAF1453BPHH
>3    NA                                      JAF1453BPAP
>_______________________________________________
>cisco-nsp mailing list  cisco-nsp at puck.nether.net
><https://puck.nether.net/mailman/listinfo/cisco-nsp>https://puck.nether.net/mailman/listinfo/cisco-nsp
>archive at 
><http://puck.nether.net/pipermail/cisco-nsp/>http://puck.nether.net/pipermail/cisco-nsp/




Tim Stevenson, tstevens at cisco.com
Routing & Switching CCIE #5561
Distinguished Technical Marketing Engineer, Cisco Nexus 7000
Cisco - http://www.cisco.com
IP Phone: 408-526-6759
********************************************************
The contents of this message may be *Cisco Confidential*
and are intended for the specified recipients only.