[c-nsp] Cisco 6500/Sup32 Sub-interface MTU Issue

[James Baker]

Hi,

You should be able to set the MTU on the xconnect if you have "Per
Subinterface MTU for Ethernet over MPLS (EoMPLS)" feature in your IOS,
try the following;

interface GigabitEthernet6/1.100
description IP Downlink to customer
encapsulation dot1Q 100
xconnect x.x.x.x 100 encapsulation mpls
 mtu 1500

FYI this does not enforce the MTU setting on the data plain however it
should allow you to xconnect to other interfaces with differing MTU's.

Kind regards

James


This email has been swept by Webroot for viruses. Any files transmitted with it are confidential and intended solely for the email recipient. If you are not the intended recipient please delete this email immediately. Be aware that any disclosure, copying, distribution or use of the contents of this information is prohibited. If you have received this email in error please notify the system administrator. Please note that any views or opinions presented in this email are solely those of the author and do not necessarily represent those of the company. Finally, the recipient should check this email and any attachments for the presence of viruses.


GCI Com incorporates the following Group Companies:
GCI Telecom Group Limited Reg. No. 5396496, Edge Telecommunications Ltd Reg. No. 5748740, Edge Telecom Ltd Reg. No. 3101247, IP Infrastructures Ltd Reg. No. 4657026, Invomo Ltd Reg. No. 6267056, NetServices UK Ltd Reg. No. 7118768, WAN Services Ltd Reg. No. 4082862. All Registered in England and Wales, Registered Office: Global House, 2 Crofton Close, Lincoln, LN3 4NT