[c-nsp] ME3600x sub-interfaces

[Thomas Braun]

Hi Eric,

this is a switch.

You have to configure a SVI Interface.

conf t
vlan 55
int vlan 55
ip add X.X.x.X


if you want to use more vlans on a port you have to use switchport mode
trunk and you should remobe the comannd switchport access vlan 55.

Regards
Thomas

> Are sub-interfaces supported on the ME3600x?  Or is there some special formula 
> that I need to enable them?
> 
> Cisco IOS Software, ME360x Software (ME360x-UNIVERSALK9-M), Version 15.2(4)S, 
> RELEASE SOFTWARE (fc1)
> License Level: AdvancedMetroIPAccess
> License Type: Permanent
> 
> interface GigabitEthernet0/1
>  no switchport
>  ip address 192.168.111.2 255.255.255.0
> !
> interface GigabitEthernet0/2
>  description test interface
>  switchport access vlan 55
>  switchport mode trunk
> 
> me3600-2(config)#int g0/1.1
>                       ^
> % Invalid input detected at '^' marker.
> 
> me3600-2(config)#int g0/2.1
>                       ^
> % Invalid input detected at '^' marker.
> 
> 
> 
> 
>  Much appreciated, Eric
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>