[c-nsp] ME3600x sub-interfaces

[Waris Sagheer (waris)]

sub interface is not supported but you can use SVI to achieve the same.

-Waris

On Oct 26, 2012, at 10:41 AM, "Eric A Louie" <elouie at yahoo.com> wrote:

> Are sub-interfaces supported on the ME3600x?  Or is there some special formula 
> that I need to enable them?
> 
> Cisco IOS Software, ME360x Software (ME360x-UNIVERSALK9-M), Version 15.2(4)S, 
> RELEASE SOFTWARE (fc1)
> License Level: AdvancedMetroIPAccess
> License Type: Permanent
> 
> interface GigabitEthernet0/1
> no switchport
> ip address 192.168.111.2 255.255.255.0
> !
> interface GigabitEthernet0/2
> description test interface
> switchport access vlan 55
> switchport mode trunk
> 
> me3600-2(config)#int g0/1.1
>                      ^
> % Invalid input detected at '^' marker.
> 
> me3600-2(config)#int g0/2.1
>                      ^
> % Invalid input detected at '^' marker.
> 
> 
> 
> 
> Much appreciated, Eric
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/