[c-nsp] ME3600x sub-interfaces

[Andrew K.]

A downfall for using the SVI on the ME3600 is you can not apply an 
inbound/outbound policy map to the SVI.

We are applying them on the layer 2 trunk interface, gets annoying when 
you can to aggregate the rate-limit between multiple interfaces.

(as for version me360x-universalk9-mz.152-2.S1.bin)

On 10/26/2012 1:54 PM, Waris Sagheer (waris) wrote:
> sub interface is not supported but you can use SVI to achieve the same.
>
> -Waris
>
> On Oct 26, 2012, at 10:41 AM, "Eric A Louie"<elouie at yahoo.com>  wrote:
>
>> Are sub-interfaces supported on the ME3600x?  Or is there some special formula
>> that I need to enable them?
>>
>> Cisco IOS Software, ME360x Software (ME360x-UNIVERSALK9-M), Version 15.2(4)S,
>> RELEASE SOFTWARE (fc1)
>> License Level: AdvancedMetroIPAccess
>> License Type: Permanent
>>
>> interface GigabitEthernet0/1
>> no switchport
>> ip address 192.168.111.2 255.255.255.0
>> !
>> interface GigabitEthernet0/2
>> description test interface
>> switchport access vlan 55
>> switchport mode trunk
>>
>> me3600-2(config)#int g0/1.1
>>                       ^
>> % Invalid input detected at '^' marker.
>>
>> me3600-2(config)#int g0/2.1
>>                       ^
>> % Invalid input detected at '^' marker.
>>
>>
>>
>>
>> Much appreciated, Eric
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
>