[c-nsp] ASR Faulty Sensor

[Antonio Soares]

Thank you Hagen. Did they tell you what is the impact of this ? We are
thinking about not doing anything :)


Regards,

Antonio Soares, CCIE #18473 (R&S/SP)
amsoares at netcabo.pt
http://www.ccie18473.net



-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Hagen AMEN
Sent: terça-feira, 22 de Janeiro de 2013 22:23
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] ASR Faulty Sensor

Antonio Soares wrote:

*> Anyone has seen something like this ?
>
> ASR1006# show facility-alarm status
> System Totals  Critical: 1  Major: 0  Minor: 0
>
> Source              Severity      Description [Index]
> ------              --------      -------------------
> Temp: Center 0/15          CRITICAL      Faulty Temperature Sensor [0]
>
> We are not able to clear this alarm. What should be done here ?*

Antonio, I've had that very issue on an ASR1006. That sensor (Center 0/15)
is located on SIP 0. If you do a 'show platform hardware slot 0 sensor prod
all', you should see sensor ID 15 isn't being polled (the "last polled"
field wasn't the same).

I opened a TAC case back in June, and was advised to power cycle the SIP.
The sensor is located on the SIP, not the chassis. A SIP reload, as part of
an already scheduled ISSU, cleared the sensor state. It has not recurred.
No bug ID was ever revealed, if it exists.

--
Hagen
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/