[c-nsp] ME-3600 Can't see ip pim vrf neighbor

[Fredrik Vöcks]

I have MVPN running on ME3600-X. Most common things to forget is ip pim
spare-mode on loopback interface or ip multicast-routing vrf xyz.

Please post relevant config.

Fredrik Vöcks
Senior IP Network Engineer



On 23 May 2013 08:38, PlaWanSai <pws_admin at thaicpe.com> wrote:

> I try to run Multicast VPN on the ME-3600 back-to-back with the 7609. It
> does not see pim neighbor. I tested on 15.1(2)EY4, 15.3(1)S and 15.3(2)S
> IOS
> version. I used this configuration between 7609 is work.
>
>
>
> test-co3600#sho ip pim vrf IPTV-M nei
>
> PIM Neighbor Table
>
> Mode: B - Bidir Capable, DR - Designated Router, N - Default DR Priority,
>
>       P - Proxy Capable, S - State Refresh Capable, G - GenID Capable
>
> Neighbor          Interface                Uptime/Expires    Ver   DR
>
> Address
>  Prio/Mode
>
> test-co3600#
>
>
>
> Thank you very much.
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>