[c-nsp] Cisco ME3x00 Egress Policie - Denied by Cisco/IOS!

[Mattias Gyllenvarg]

It no just that 11 x 10 > 100 ?

Perhaps you could show us the conf?

//Mattias


On Mon, May 12, 2014 at 3:10 PM, James Bensley <jwbensley at gmail.com> wrote:

> Hi All,
>
> Has anyone encountered this issue on the ME3600/ME3800s;
>
> Cisco 2960 - Layer 2 device terminating Layer 2 connections
> |
> | Layer 2 Trunk on 100Mbps port
> |
> Cisco ME3800 - Various layer 2 connections trunked up in VLANs for
> termination on ME3800
>
> We are trying to apply some policers on the ME3800 for multiple 10Mbps
> circuits being delivered on the 2960 because some of them are on
> faster bearers. The problem is that when you try to apply a policy on
> the ME3x00 series and you add in an 11th policer for 10Mbps it throws
> up an error saying the port is oversubscribed and the config isn't
> allowed. You can't police 11+ VLANs for example to 10Mbps on a 100Mbps
> port.
>
> These devices are meant to go near/on the access layer where
> oversubscription lives :)
>
> Has anyone encountered this and has anyone overcome it?
>
> We have a TAC case open, they are almost definately going to say
> "that's what is supposed to happen".
>
> Cheers,
> James.
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>



-- 
*Med Vänliga Hälsningar / Best Regards*
*Mattias Gyllenvarg*