[c-nsp] ACE30 Config

[Chris Knipe]

Thanks Mike.

There's no existing svclc's on the 6500, so vlan-group 10 is unused.  I was
mainly concerned that the 6500 would stop switching VLAN101 after it's been
assigned to the svclc.

Just wanted to get confirmation on that before I drop all my traffic
accidentally :-)

On Tue, Aug 16, 2016 at 2:20 PM, harbor235 <harbor235 at gmail.com> wrote:

> Config looks good for the 6500 portion of the config as long as the vlans
> you have specified for vlan-group 10 are unused?
> I also assume you have created the vlans as well?
>
> Mike
>
> On Tue, Aug 16, 2016 at 8:07 AM, Chris Knipe <savage at savage.za.org> wrote:
>
>> Hi Guys,
>>
>> Quick question... I'm about to install my first ACE30 into a 6500
>> (SUP720)... Just a quick question about the svclc if I may...
>>
>> I already have VLAN101 with all my rservers (currently in production,
>> being
>> fed from a old LB we'll be replacing with the ACE30).
>>
>> I created  a new VLAN102 which will be used for the customer facing leg of
>> the ACE...
>>
>> Config:
>> svclc vlan-group 10 101,102
>> svclc module 1 vlan-group 10
>> svclc multiple-vlan-interfaces
>>
>> Are those commands safe?  I'm not sure whether or not the switch will drop
>> traffic to VLAN101 which is currently doing some 2Gbps in traffic.
>>
>> --
>>
>> Regards,
>> Chris
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>>
>
>


-- 

Regards,
Chris Knipe