[c-nsp] telemetry on IOS XE

[Robert Hass]

Yes I did

#sh run | inc netconf
netconf-yang

#show platform software yang-management process
confd            : Running
nesd             : Running
syncfd           : Running
ncsshd           : Running
dmiauthd         : Running
nginx            : Running
ndbmand          : Running
pubd             : Running
gnmib            : Not Running

On Sat, Jun 20, 2020 at 12:02 AM Dave Bell <dave at geordish.org> wrote:

> Have you enabled netconf-yang?
>
> On Fri, 19 Jun 2020 at 20:46, Robert Hass <robhass at gmail.com> wrote:
>
>> Hi
>> I'm trying to run telemetry on IOS XE (Catalyst 9300) but without lack.
>>
>> My config:
>>
>> test#sh run | sec tele
>> telemetry ietf subscription 1
>>  encoding encode-kvgpb
>>  filter xpath
>> /process-cpu-ios-xe-oper:cpu-usage/cpu-utilization/five-seconds
>>  source-address 10.0.0.147
>>  source-vrf Mgmt-vrf
>>  stream yang-push
>>  update-policy periodic 500
>>  receiver ip address 10.0.3.16 12345 protocol grpc-tcp
>>
>> But it's not working:
>> #show telemetry ietf subscription all
>> The process for the command is not responding or is otherwise unavailable
>>
>> Any ideas ?
>>
>> Running IOS XE  17.02.01
>>
>> Rob
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>>
>