[cisco-voip] from E1 to E1

[Ýsmail CAN]

hello,
 
I have a as5350 cisco gw. It has 4 E1s, two of them are not used. To work IP-to-IP I want to connect 2 E1s each other...
 
IP------------------------->      ---------------
                             GW               |
IP<-------------------------      --------------
 
I have made config but thereason is no route to destination..
Can you help me?
Thanks
ismail
 
controller E1 3/0
 pri-group timeslots 1-31
!
controller E1 3/1
 pri-group timeslots 1-31

interface Serial3/0:15
 no ip address
 ip mroute-cache
 isdn switch-type primary-qsig
 isdn overlap-receiving
 isdn protocol-emulate network
 isdn incoming-voice modem
 no cdp enable
!
interface Serial3/1:15
 no ip address
 ip mroute-cache
 isdn switch-type primary-qsig
 isdn incoming-voice modem
 fair-queue 64 256 0
 no cdp enable

voice-port 3/0:D
 input gain 6
 echo-cancel coverage 16
 cptone TR
 timeouts interdigit 5
 timeouts ringing infinity
 bearer-cap Speech
!
voice-port 3/1:D
 input gain 6
 echo-cancel coverage 16
 cptone TR
 timeouts interdigit 5
 timeouts ringing infinity
 bearer-cap Speech

dial-peer voice 97 pots
 huntstop
 destination-pattern 40T
 direct-inward-dial
 port 3/0:D
!
dial-peer voice 98 pots
 huntstop
 incoming called-number .T
 port 3/1:D
!
dial-peer voice 6666 voip
 huntstop
 destination-pattern 40T
 session target ipv4:a.b.c.d

 
 
 
 
 
 
 

			
---------------------------------
Do you Yahoo!?
 Check out the new Yahoo! Front Page. www.yahoo.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20041110/093a4cfb/attachment.html