[cisco-voip] CMM Config with ACT

[Andrew Dignan]

Anyone out there have an actual working config on the 6500 side and the
CMM side?  The CMM configuration guide on CCO has many inacuracies and I
have had a TAC case open for 6 days now with no luck.  I am just getting
tired of working this case, it doesn't appear there are any experts on the
CMM at TAC (I know there are but I just haven't gotten passed around to
one yet).  We have the CMM up and working properly, routing calls through
the PRI's and T1 cas links.  However, the ACT card has not worked properly
yet.  When trying to initiate a conference, the bridge is setup and you
can do a "show mediacard conference" to verify its the active conference
bridge, but no audio gets passed between the partys on the call.  The rx
and tx increments on the phones if you hit the ? button but no audio.  If
you hit a button on the phone, all partys on the conference can hear the
dtmf tone which is odd, but no actual voice.

The phone vlan can ping the Gig0/1 interface of the CMM, the phone vlan
can ping the ip addresses assigned to the FE interfaces for the ACT card. 
The conference bridge is registered in CM.  The switch side has the Gig7/1
and FE 7/1-4 all in the same VLAN.

TIA,

Andy