[cisco-voip] Caller ID

[Ward Knutson]

I recently changed my gateway from a H.323 with 1-T1 PRI to a MGCP with
2-T1 PRI's.  The T1's are pooled and I am having trouble passing caller
ID information on outgoing calls.  Before I was able to set the Caller
ID DN to 701355XXXX and it worked fine.  Since I have two different set
of DID's tied to these T1's I can't use the same settings.  I tried 10
X's and also tried to leave the Caller ID DN blank but then I get the
number that is associated to the T1 from the service provider.  This it
how I have it set now.

 

Calling Line ID Presentation                                Allowed

Calling Party Selection                                       Originator

Called party IE number type unknown                  Cisco CallManager

Calling party IE number type unknown                 Cisco CallManager

Called Numbering Plan                                       Cisco
CallManager

Calling Numbering Plan                                      Cisco
CallManager

Number if digits to strip                                       1

Caller ID DN
7013553000

SMDI Base Port                                                 0

 

If you have any ideas they would be greatly appreciated.

 

 

Ward Knutson

Network Coordinator

Bismarck Public Schools

Bismarck, North Dakota

ward_knutson at educ8.org

701-355-3037 Office

701-527-4034 Cell

 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060421/c71981d8/attachment.html