[cisco-voip] SIP call won't go thru

[DeRooy, Aaron H]

Here's my dial peers:

voice-port 2/0:0
!
voice-port 2/1:0
!
dial-peer cor custom
!
dial-peer voice 202 voip
 incoming called-number .
 session protocol sipv2
 session target ipv4:13.130.0.22
 codec g711ulaw
!
dial-peer voice 100 pots
 destination-pattern 9.......
 port 2/1:0


Here's the "show call active voice bri" Notice the "no requesed circuit
(44)". My circuit is a DS0 T1. Any idea? The dial peers seem to be
matching OK.

13A5 : -1330532810ms.403 +-1 +1630 pid:100 Originate 92658093
 dur 00:00:00 tx:0/0 rx:0/0 2C  (no requested circuit (44))
Telephony 2/1:0 (405) [2/1.10] tx:0/0/0ms None noise:0dBm acom:0dBm

13A5 : -1330532820ms.404 +-1 +1680 pid:202 Answer aaron.derooy
 dur 00:00:00 tx:0/0 rx:0/0 2C  (no requested circuit (44))
 IP 13.231.116.125:36182 rtt:0ms pl:0/0ms lost:0/0/0 delay:0/0/0ms
g711ulaw

Aaron H. DeRooy 
Cisco CCNP&CQS-CIPTSS;  Infrastructure Specialist
EDS PE/Dedicated Client Engineering - Americas
585.265.8093  (8*225)
585.202.8296  Nextel Cell
Bldg. 200 - 800 Phillips Rd.
MS:0200-08A (Cube W2-15)
Webster, NY 14580