[cisco-voip] Analog line / FXO Port issues

[James Dust]

Thanks Candace, are you referring to an MGCP gateway as we are using
H323.

James

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Candace Holman
Sent: 15 February 2006 16:56
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Analog line / FXO Port issues

I may not be understanding your question correctly, as I'm not sure why
you set this up with plar. As an alternative, you should be able to
easily set up a CallManager route group with each analog line as a
member. You can use the route group in your route plans for that number
and it will work to deliver calls to a single number to the various
analog lines.

Candace
> Subject:
> RE: [cisco-voip] Analog line / FXO Port issues
> From:
> "James Dust" <james.dust at charles-stanley.co.uk>
> Date:
> Wed, 15 Feb 2006 16:23:36 -0000
> To:
> <cisco-voip at puck.nether.net>
>
> To:
> <cisco-voip at puck.nether.net>
>
>
> Can anyone help us with this as we are no further forward.
>
> ----------------------------------------------------------------------
> --
> *From:* cisco-voip-bounces at puck.nether.net
> [mailto:cisco-voip-bounces at puck.nether.net] *On Behalf Of *Nick Kassel
> *Sent:* 10 February 2006 14:24
> *To:* cisco-voip at puck.nether.net
> *Subject:* [cisco-voip] Analog line / FXO Port issues
>
> We are currently trying to set up one of our small remote sites 
> utilising there 4 existing analogue lines, which have one number 
> spread across them, we are a using a 4 port vic2-4fxo card in a 1760.
> We can make outgoing and incoming calls but are having issues with 
> multiple incoming calls, we would like each phone to have just the one

> shared DN 86820 but can't seem to get it to work so have been playing 
> about with the voiceport and dialpeer configuration by adding another 
> number to connection plar and on line 2 on the phones, please can any 
> one help out with the correct way to set it up, below is our current 
> config so far.
>
> !
>
> voice-port 1/0
>
> supervisory disconnect anytone
>
> signal groundStart
>
> output attenuation -4
>
> cptone GB
>
> connection plar 86820
>
> impedance complex2
>
> description Wimborne Main Line
>
> !
>
> voice-port 1/1
>
> supervisory disconnect anytone
>
> signal groundStart
>
> output attenuation -4
>
> cptone GB
>
> connection plar 86821
>
> impedance complex2
>
> description Wimborne Main Line 2
>
> !
>
> voice-port 1/2
>
> supervisory disconnect anytone
>
> signal groundStart
>
> output attenuation -4
>
> cptone GB
>
> connection plar 86820
>
> impedance complex2
>
> description Wimborne Main Line 3
>
> !
>
> voice-port 1/3
>
> supervisory disconnect anytone
>
> signal groundStart
>
> output attenuation -4
>
> cptone GB
>
> connection plar 86820
>
> impedance complex2
>
> description Wimborne Main Line 4
>
> !
>
> no mgcp package-capability res-package
>
> no mgcp package-capability fxr-package
>
> no mgcp timer receive-rtcp
>
> !
>
> !
>
> !
>
> !
>
> dial-peer voice 1 voip
>
> preference 1
>
> destination-pattern 86820
>
> progress_ind setup enable 3
>
> session target ipv4:172.30.0.2
>
> dtmf-relay h245-alphanumeric
>
> no vad
>
> !
>
> dial-peer voice 20 pots
>
> preference 8
>
> destination-pattern 9.T
>
> port 1/3
>
> !
>
> dial-peer voice 21 pots
>
> preference 9
>
> destination-pattern 9.T
>
> port 1/2
>
> !
>
> dial-peer voice 22 pots
>
> preference 10
>
> destination-pattern 9.T
>
> port 1/1
>
> !
>
> dial-peer voice 2 voip
>
> preference 2
>
> destination-pattern 86820
>
> progress_ind setup enable 3
>
> session target ipv4:172.30.0.2
>
> dtmf-relay h245-alphanumeric
>
> no vad
>
> Regards
>
> Nick
>


_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
***********************************************************************************************

The information contained in this e-mail is strictly confidential, some or all
of which may be legally privileged. It is for the intended recipient only.
Access to this e-mail by any other person is prohibited. If you are not the
intended recipient, any use, disclosure, copying, printing, distribution of,
replying to or any action taken or omitted to be taken in reliance on this
e-mail, is prohibited and may be unlawful. Please contact the sender immediately
should this e-mail have been incorrectly addressed or transmitted.

You accept that any instructions are deemed to have been given at the time the
recipient(s) accesses them and that delivery receipt does not constitute
acknowledgement or receipt by the intended recipient(s). You accept that there
may be a delay in processing the instructions received from e-mails after
Charles Stanley has received them. You are advised that urgent, time sensitive
and confidential communications should not be sent by e-mail. 

You acknowledge that e-mails are not secure and you accept the risk of
malfunction, viruses, unauthorised interference, mis-delivery or delay.
************************************************************************************************


Charles Stanley & Co. Ltd
Registered Office: 25 Luke Street London EC2A 4AR

Tel: 0207 739 8200 Fax: 0207 739 7798
Registered in England No. 1903304

Charles Stanley Sutherlands and Tozer Wingate are divisions of Charles Stanley & Co. Ltd

Authorised and Regulated by the Financial Services Authority, Member of the
London Stock Exchange, International Securities Markets Association, and The London International Financial Futures &
Options Exchange.

This footnote also confirms that this email message has been swept by McAfee
VirusScan and SurfControl Email Filter software.