[cisco-voip] crs recording are pretty bad

[Brandon Bennett]

Also check the CPU on the CRS server.  I've seen people pull reports
at the same time as recording causing gargling.

~Brandon

On 5/8/06, Erick Bergquist <erickbe at yahoo.com> wrote:
>
>
> What codec are you using and what is the codec sampling rate set to (CCM, on
> the gateway, etc). CRS likes 20ms and I have seen garbled recordings when
> sampling rate was set to something other then 20ms.
>
> Also check to make sure all interfaces end-to-end that the voice stream
> passes through have no errors.
>
>
> ----- Original Message ----
> From: James Grace <jgrace at digitelusa.net>
> To: cisco-voip at puck.nether.net
> Sent: Monday, May 8, 2006 5:27:23 PM
> Subject: [cisco-voip] crs recording are pretty bad
>
>
>
>
>
> Is there anything I can do to clear up the crs recording for my cad agents..
>  in the lab this worked just fine,  but we only test with 2 phones.   I
> confg the span port with the vlan im spanning aswell as without.   The
> recording are all garble.  I have separate vlans for native, data and voice
> on the switch.  Monitor works great.
>
>
>
> James D. Grace
>
> CCNP CCNA MCSE MCDBA
>
> Sr. System Engineer / Professional Svc.
>
> Digitel Corporation
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
>