[cisco-voip] trying outbound call on Centrex POTS lines

[James Grace]

So  your first pattern should used the first 9 to access the lines. I
discard predot  and send 9+number (this could be 9+10 dig   or 9+1+10   or
9+international dialing ).   So will I run into issues with just sending
9+number over the the hosted site with out some type of pause for delay for
that ( 9 ).  Because this 9 allow the hosted site to make the call out of
there system

 

  _____  

From: Kevin Thorngren [mailto:kthorngr at cisco.com] 
Sent: Wednesday, May 10, 2006 3:57 PM
To: James Grace
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] trying outbound call on Centrex POTS lines

 

Are you saying that the Centrex is expecting to see 9 + number for outbound
calls?

If so you have the flexibility of having the users dial 9 + 9 + number (use
a 9.9[2-9]XX[2-9]XXXXXX pattern and predot discard) or just 9 + number (use
a 9[2-9]XX[2-9]XXXXXX pattern and no digit manipulation). You just need to
make sure the CCM sends the appropriate digits to the centrex.

Kevin
On May 10, 2006, at 3:36 PM, James Grace wrote:

Hello we have a cm with 4 port fxo config as mgcp.  We are connecting 4
Centrex POTS lines to the 2811 GW.  In the old system (Norstar)  I believe
the users had to hint the 9 to access to centrex lines  and then a 9 again
plus the rest of the number to dial out..  Since the centrex is a hosted
type solution,  what will be the best way to config this with my cisco
solution.  Will I have to tell the users to do it the same way as before.
9..9 + number
 
James D. Grace 
CCNP CCNA MCSE MCDBA
Sr. System Engineer / Professional Svc.
Digitel Corporation
 
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060510/4b0cb407/attachment-0001.html