[cisco-voip] Attendant console queue MOH resource

[Erik Erasmus (E)]

Hi

 

I am using an H323 gateway at HQ - and not talking about the MOH under
SRST using branch flash and fooling the phones with the signalling to
think they are listening to multicast MOH from the HQ site. Simply - a
case of because we are going that route for branches we enabled
multicast MOH at HQ and then realised MOH towards PSTN stopped working
on the h323 gateway. That is when I started looking at the perf mon
counters for cisco MOH device and plying with the the require MTP tick
on the ccm gateway.

 

 

 

Did not have time to play on this again - was pulled off to other
work. 

 

 

 

Erik Erasmus (B Eng)

CCIE # 4408

LAN/WAN Design & System Integration

Telkom SA

': +27 12 680 8320

*: +27 12 680 7388

*: +27 82 4106420 

*:  erasmue4 at telkom.co.za

 

         

 

________________________________

From: Fred Nielsen [mailto:fwn at feasible.net] 
Sent: 29 November 2006 08:35 PM
To: Erik Erasmus (E); 'Cheng, Cathy (VIC)'
Cc: cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] Attendant console queue MOH resource

 

Is your gateway MGCP?  If so, are you using the ccm-manager
music-on-hold command on the router?

 

Also, curious about this, wondering if you are getting unicast because
you have opted to insert an MTP into the audio flow.  If you uncheck,
does it attempt to use a multicast port?

 

________________________________

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Erik Erasmus
(E)
Sent: Wednesday, November 29, 2006 2:11 AM
To: Cheng, Cathy (VIC)
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Attendant console queue MOH resource

Should be able to

 

You can create a dedicated devpool for attendant MOH so that attendant
can use a different MOH source than normal users. I have done that
before. The problem I had was that even when I select multicast for
the source I noticed that 9by looking at the cisco MOH device in perf
mon) that callers from the PSTN to the attendant Q or when placed on
hold get unicast MOh. I also had to tick the "require media
termination" on my gateway config in CCM otherwise I could not get any
MOH out to pstn callers as soon as I enabled multicast MOh

 

 

 

 

Erik Erasmus

 

________________________________

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Cheng, Cathy
(VIC)
Sent: 28 November 2006 11:56 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Attendant console queue MOH resource

 

Hi Guys, 

On the AC pilot point configuration page, Common Profile & Device Pool
are both related to MOH resource, Which one is AC queue will use?

Does AC queue can work with multicast MOH resource? 

Thanks 

Cathy 

 

E-mail Disclaimer: 
Any personal information in this e-mail must be handled in accordance
with the provisions of the Privacy Act 1988 [Cth].  The information
contained in the e-mail may be confidential and if the person
receiving the e-mail is not the intended recipient they should
immediately advise ARCBS by e-mail response to the ARCBS sender and
then deal with the e-mail as directed by ARCBS. The views expressed in
the e-mail are those of the individual sender unless otherwise stated
to be the views of ARCBS. No warranties are provided that the e-mail
is computer virus or other defect free.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This e-mail and its contents are subject to the Telkom SA Limited
e-mail legal notice available at 
http://www.telkom.co.za/TelkomEMailLegalNotice.PDF
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

 



~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This e-mail and its contents are subject to the Telkom SA Limited
e-mail legal notice available at 
http://www.telkom.co.za/TelkomEMailLegalNotice.PDF
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20061130/539e9e12/attachment-0001.html 
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/jpeg
Size: 1611 bytes
Desc: image001.jpg
Url : https://puck.nether.net/pipermail/cisco-voip/attachments/20061130/539e9e12/attachment-0001.jpe