[cisco-voip] Getting CND to work when calling from CCM to CME via H323

[Kris Seraphine]

You might be having an issue with CME trying to use H.450 for updating the
caller id for calls to CCM (which doesn't support it).  I don't know what
versions of code you're using but the CME design guide says to disable H.450.
I'm honestly not sure if you actually need to disable H.450 totally, or if
it's sufficient to enable H.450.12.  You could try putting the following
commands under your voip dial peer

 no supplementary-service h450.2

  no supplementary-service h450.3

Maybe someone else can give you more concrete advice.



On 4/17/07, Nathan Reeves <nathan.a.reeves at gmail.com> wrote:
>
> Been trying to fix an issue with CND when calling from a CCM system
> through to a CME via H323.
>
> Got things working fine when you call from CME to CCM.  Call is
> placed, destination endpoint rings and you see the correct names and
> numbers displayed on both source and destination phones.
>
> When calling from CCM to CME, the destination endpoint rings and it
> shows the name sent from CCM.  The CCM phone however only shows the
> dialled number and no name.
>
> One thing I did find was that when I created an empty voip dial peer
> on the CME system, when I call from CCM to CME, the CCM Phone displays
> the CME extension name but no number.  Remove the dial peer and the
> ccm phone only shows the dialled number.
>
> Anyone got any suggestions on what I'm doing wrong here?  The CME
> setup is extremely basic  with only a voip dial peer to call back to
> the CCM system.
>
> Thanks
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>



-- 
kris seraphine
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070417/7e8b1c1a/attachment.html