[cisco-voip] getting dial-tone when dialing into FXO port while in SRST mode

[Erick Bergquist]

The connection plar command is what you need with FXOs in H.323 (SRST)
mode. The MGCP config push won't remove it.

On 6/12/07, Lelio Fulgenzi <lelio at uoguelph.ca> wrote:
>
>
> Ok, I know this is simple, but I can't find the solution. Or at least what I
> think I need.
>
> While in SRST mode, when I dial into the FXO port I get dial-tone. I need it
> to go to a particular number. In my readings, I see that you can configure
> "connection plar" on the voice port, but from what I gather I'm not supposed
> to add config statements to the voice port when I'm using "ccm-manager
> config".
>
> I reordered my dial-peers so the 999020 is at the top and my 20 is after it.
> I thought I could add the "incoming called number" like I did on the PRIs,
> but no go. I was thinking I just needed to configure the dial-peer voice 20
> to modify the inbound calling number to match my extension.
>
> Any ideas?
>
> !
> dial-peer voice 999020 pots
>  service mgcpapp
>  port 0/2/0
> !
> dial-peer voice 20 pots
>  incoming called-number 61001
>  port 0/2/0
> !
>
>
>
> When I dial in I get
>
> .Jun 12 18:10:25: %CALL_CONTROL-6-APP_NOT_FOUND: Application mgcpapp in
> dial-peer 999020 not found.  Handing callid 11 to the alternate app Default.
>
>
>
> --------------------------------------------------------------------------------
> Lelio Fulgenzi, B.A.
> Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
> (519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
> ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
> "Buffalo buffalo Buffalo buffalo buffalo buffalo Buffalo buffalo."      WJR
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>