[cisco-voip] CCM adding a 1760 w/FXO - inbound calls go directly to Dialtone

[Brian E. Wyland]

We added a 1760 with a 2 port FXO to accept inbound calls and route via
CCM.

I had put in the Connection Plar command but since we are configuring it
via MGCP it doesn't matter.

I assume this is something simple, but I am missing it.

BTW the port configuration on the Gateway has a calling search space
that can see everything.

You call the number and the FXO picks up and then you get a Dialtone
from the CCM.

Here is the port related configuring the FXO:

voice-port 3/1
 supervisory disconnect anytone
 signal groundStart
 no vad
 no comfort-noise
 timing hookflash-out 500

dial-peer voice 99931 pots
 service mgcpapp
 port 3/1

What am I missing?  I have been suck in PRI land too long.


-- Brian Wyland