[cisco-voip] CCM adding a 1760 w/FXO - inbound calls go directly to Dialtone

[Craig Staffin]

on the port in CCM you need to tell it what DN it is supposed to be or
ring.  I think it is called Attendant DN

Craig

On 3/14/07, Brian E. Wyland <BWyland at netrixllc.com> wrote:
>
> We added a 1760 with a 2 port FXO to accept inbound calls and route via
> CCM.
>
> I had put in the Connection Plar command but since we are configuring it
> via MGCP it doesn't matter.
>
> I assume this is something simple, but I am missing it.
>
> BTW the port configuration on the Gateway has a calling search space
> that can see everything.
>
> You call the number and the FXO picks up and then you get a Dialtone
> from the CCM.
>
> Here is the port related configuring the FXO:
>
> voice-port 3/1
> supervisory disconnect anytone
> signal groundStart
> no vad
> no comfort-noise
> timing hookflash-out 500
>
> dial-peer voice 99931 pots
> service mgcpapp
> port 3/1
>
> What am I missing?  I have been suck in PRI land too long.
>
>
> -- Brian Wyland
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>



-- 
Craig Staffin
Craig at staffin.org
(H) 262-437-7313
(C) 262-613-6003
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070314/58292662/attachment.html