[cisco-voip] Analog phones cant transfer calls on 2811 acting as H323 gw to UCM 4.2(3)
Cucumber Green
greencucumber2007 at yahoo.com
Thu Sep 20 11:53:04 EDT 2007
Analog phones can send and receive calls from IP phones, but
when pressing the hookflash key at the analog phone, the analog phone does not get a dial tone in order to transfer the call :(
Phones are hooked into FXS ports on a 2811 and will use G729 codec.
I have already checked the "Media Termination Point required" check box in the gateway configuration at call manager (using unified call manager 4.2(3) ). I thought that would do the trick, but it didnt, any ideas?
This is the gateway config (IOS version 12.4(3g) spservicesK9)
!
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
ip subnet-zero
!
!
ip cef
!
!
no ip domain lookup
!
voice-card 0
no dspfarm
!
!
!
!
interface Loopback0
ip address X.X.X.X 255.255.255.255
h323-gateway voip bind srcaddr X.X.X.X
!
!
ip classless
ip route 0.0.0.0 0.0.0.0 X.X.X.X 254
!
!
control-plane
!
!
!
voice-port 0/1/0
signal loopStart
!
voice-port 0/1/1
signal loopStart
!
dial-peer voice 10 pots
destination-pattern 50001
port 0/1/0
!
dial-peer voice 20 pots
destination-pattern 50002
port 0/1/1
!
dial-peer voice 1 voip
preference 1
destination-pattern 1...
session target ipv4:X.X.X.X
dtmf-relay h245-alphanumeric
codec g729r8 bytes 40
ip qos dscp cs3 media
ip qos dscp cs3 signaling
!
dial-peer voice 4 voip
preference 2
destination-pattern 1...
session target ipv4:X.X.X.X
dtmf-relay h245-alphanumeric
codec g729r8 bytes 40
ip qos dscp cs3 media
ip qos dscp cs3 signaling
!
---------------------------------
Be a better Globetrotter. Get better travel answers from someone who knows.
Yahoo! Answers - Check it out.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070920/5ee733df/attachment.html
More information about the cisco-voip
mailing list