[cisco-voip] silly qs: change pri time slot
Jonathan Charles
jonvoip at gmail.com
Thu Apr 3 11:11:11 EDT 2008
Right... so you will need to re-add the port commands to all of your
dial-peers...
Kind of a pain, isn't it...
Jonathan
On Thu, Apr 3, 2008 at 10:05 AM, Patrick Diener
<patrick.diener at gmail.com> wrote:
> and since you delete your voice-port and add it again it will be gone
> from all your dial-peers pointing to it.
>
> Regards
> Patrick
>
>
>
> On Thu, Apr 3, 2008 at 4:24 PM, Ryan Ratliff <rratliff at cisco.com> wrote:
> > In summary to change the timeslots for the PRI you have to remove the
> > existing PRI config.
> > 1. shut down the voice-port for the PRI
> > 2. shut down the serial interface for the PRI (maybe not necessary
> > but I do it)
> > 3. 'no pri-group timeslots...' on the controller you want to change
> > 4. reconfigure pri-group
> > 5. 'no shut' the serial interface for the PRI
> > 6. 'no shut' the voice-port for the PRI
> >
> > This should take care of it for you. Shutting the controller itself
> > is an option, but like the serial interface may not be necessary.
> >
> > -Ryan
> >
> >
> >
> > On Apr 3, 2008, at 9:26 AM, Jonathan Charles wrote:
> > Also no out the existing controller pri-group timeslots command
> >
> >
> >
> > Jonathan
> >
> > On Thu, Apr 3, 2008 at 7:30 AM, Daniel Rodriguez
> > <drodriguez at fidelus.com> wrote:
> > >
> > >
> > >
> > >
> > > Shutdown the voice-port for your PRI.
> > >
> > >
> > >
> > > conf t
> > >
> > > voice-port 0/1/0:15
> > >
> > > shut
> > >
> > >
> > >
> > >
> > >
> > > From: cisco-voip-bounces at puck.nether.net
> > > [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Syed
> > > Khalid Ali
> > > Sent: Thursday, April 03, 2008 3:53 AM
> > >
> > > To: cisco-voip at puck.nether.net
> > > Subject: [cisco-voip] silly qs: change pri time slot
> > >
> > >
> > >
> > >
> > >
> > >
> > > hi
> > >
> > >
> > >
> > >
> > >
> > > previously we had a 32 channel dsp card. we had one pri and a four
> > > port fxo
> > > card. when i configured the pri group time slots it told me that
> > > maximum can
> > > be 28 as enough dsp resources not available.
> > >
> > >
> > >
> > >
> > >
> > > recently we installed another pri and another dsp but i tried to
> > > change the
> > > time slot to 31 on first pri it told me to shutdown the voice
> > > interface
> > > card.
> > >
> > >
> > >
> > >
> > >
> > > I tried shutting down the controller as well as the logical serial
> > > interface
> > > but in vain. below is the configration script:
> > >
> > >
> > >
> > >
> > >
> > > network-clock-participate wic 1
> > > !
> > >
> > >
> > > controller E1 0/1/0
> > > shutdown
> > > framing NO-CRC4
> > > pri-group timeslots 1-28 <-- need to change to 31
> > > !
> > > controller E1 0/1/1
> > > framing NO-CRC4
> > > pri-group timeslots 1-31
> > > !
> > >
> > >
> > > interface Serial0/1/0:15
> > > no ip address
> > > isdn switch-type primary-net5
> > > isdn incoming-voice voice
> > > no cdp enable
> > >
> > >
> > > !
> > > interface Serial0/1/1:15
> > > no ip address
> > > isdn switch-type primary-net5
> > > isdn incoming-voice voice
> > > no cdp enable
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > > Regards,
> > >
> > >
> > >
> > >
> > >
> > > Syed Khalid Ali
> > >
> > >
> > >
> > > _______________________________________________
> > > cisco-voip mailing list
> > > cisco-voip at puck.nether.net
> > > https://puck.nether.net/mailman/listinfo/cisco-voip
> > >
> > >
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-voip
> >
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-voip
> >
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
More information about the cisco-voip
mailing list