[cisco-voip] Enable Caller ID UNblock

[Ryan Ratliff]

Do the dial-peers on the gateway allow it to route that called party  
number correctly?

Take your number (ie 8*825555555) and use 'show dialplan number' to  
verify what dial-peer it will match.

-Ryan

On Dec 9, 2008, at 5:27 PM, David Zhars wrote:

The 2801 is in H.323

On Tue, Dec 9, 2008 at 3:59 PM, Ryan Ratliff <rratliff at cisco.com> wrote:
Is the 2801 MGCP or H.323?
With discard digits none you are sending 8*82.... to the gateway.  If  
the telco can't route this it will send back unknown/unallocated  
number and CUCM will play that tone via Annunciator.

-Ryan

On Dec 9, 2008, at 4:14 PM, David Zhars wrote:

Yes, I have some lines where we block caller ID plugged into my 2801  
router.
When we tried to call a #, that # would not accept calls from people  
who block their Caller ID.
So we tried the *82 suffix, and it did not go through.

I have created a route pattern that looks like this:
8.*82[2-9]XXXXXX
(users in this building press an 8 for an outside line)

My Discard Digits is set to <none>

The calls are still not completed (I get the Cisco "call cannot be  
completed as dialed")
Calls should go out the POTS lines on the 2801, so is it that I  
should be doing something on the 2801 and not in CCM 4.1(3)

Thanks anyone!




_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20081210/872d63dd/attachment.html>