[cisco-voip] Valcom Paging

[Voice Noob]

When I call I get the port to go off hook but it plays a stuttered tone.

On Tue, Dec 16, 2008 at 3:48 PM, Truelove_John <JTruelove at aetinc.com> wrote:

>  This is from memory.
>
>
>
> I just used 2 wires to FXO (middle of RJ11), sounds like you have that part
> right.
>
> Didn't use control1, then connected to TIP/RING # 1.
>
>
>
> You will also need to get you SW settings correct.  I think it was SW1 that
> I had to change.
>
> If I remember correctly, something was backward from the way that I was
> thinking and I had to change it.
>
>
>
> I called Valcom support and they were very helpful.
>
>
>
>
>
>
>
> *From:* cisco-voip-bounces at puck.nether.net [mailto:
> cisco-voip-bounces at puck.nether.net] *On Behalf Of *Voice Noob
> *Sent:* Tuesday, December 16, 2008 4:27 PM
> *To:* Truelove_John
> *Cc:* cisco-voip at puck.nether.net
> *Subject:* Re: [cisco-voip] Valcom Paging
>
>
>
> Can anyone tell me how to wire this to the FXO? I think I have it correct
> but it is not working. On the Valcom system I have Tip1 Ring1 Control1
> Control1 . I have the tip and ring in the middle pair on the RJ-11 and the
> control on the outside pair. I get a fast busy when I call to the system.
>
>
>
> On Thu, Dec 11, 2008 at 7:53 PM, Truelove_John <JTruelove at aetinc.com>
> wrote:
>
> I have.  FXO to 2 Valcom 9963s.
>
> I have had the Valcom 9963 lock up a couple of times which stops paging.
> Rebooting 9963 fixes the problems.
> I put the Valcom 9963s and Valcom 2006A on a power strip to quickly power
> cycle.
>
> We do a lot of paging 10,000+ pages per month on those units.
>
> No problems with disconnects.  I did have to adjust the gain on the FXO
> ports
> for volume out to the 9963s.
>
>
>
>
>
> -----Original Message-----
> From: cisco-voip-bounces at puck.nether.net on behalf of Voice Noob
> Sent: Thu 12/11/2008 4:22 PM
> To: cisco-voip at puck.nether.net
> Subject: [cisco-voip] Valcom Paging
>
> I have a customer that has a Valcom V-2924A with a Valcom V-9963 Digital
> Feedback Eliminator
>
> What type of connection would I use on the router? FXS or FXO ? Has anyone
> integrated with these? Are there any problems with disconnect or anything
> else to watch out for. Thanks for your help.
>
>
>
>
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20081216/c0e6874b/attachment.html>