[cisco-voip] CCM 6.01 NIC Speed/Duplex

[Wes Sisk]

at CLI:
admin:set network nic eth0 ?
Syntax:
set network nic eth0 param [value]
param   mandatory   auto, speed, duplex
value   mandatory   for auto  : [en/dis]
                    for speed : [10/100]
                    for duplex: [half/full]

NOTE: 1000BASE-T can only be enabled via auto-negotiation

No reboot required.  It warns you not to do it over ssh.  However I've 
always done it over ssh and worked out so far.  YMMV.

/Wes

Erick Bergquist wrote:
> What is the recommended way to set the speed/duplex in CCM 6.x?  Right
> now, have a speed/duplex mismatch I'm fixing tonight and should I set
> the server to auto and switch port, or  hard code both sides?
>
> Right now, the servers NIC Eth0 is set to auto. If I use the commands
> to hard set it, does that require a reboot of server or
> stopping/starting of any services or will it just take the changes on
> the fly?
>
> Thanks, Erick
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>