[cisco-voip] CCM 6.01 NIC Speed/Duplex

[Erick Bergquist]

Ok. Thanks.

On Jan 10, 2008 12:28 PM, Wes Sisk <wsisk at cisco.com> wrote:
> at CLI:
> admin:set network nic eth0 ?
> Syntax:
> set network nic eth0 param [value]
> param   mandatory   auto, speed, duplex
> value   mandatory   for auto  : [en/dis]
>                     for speed : [10/100]
>                     for duplex: [half/full]
>
> NOTE: 1000BASE-T can only be enabled via auto-negotiation
>
> No reboot required.  It warns you not to do it over ssh.  However I've
> always done it over ssh and worked out so far.  YMMV.
>
> /Wes
>
>
> Erick Bergquist wrote:
> > What is the recommended way to set the speed/duplex in CCM 6.x?  Right
> > now, have a speed/duplex mismatch I'm fixing tonight and should I set
> > the server to auto and switch port, or  hard code both sides?
> >
> > Right now, the servers NIC Eth0 is set to auto. If I use the commands
> > to hard set it, does that require a reboot of server or
> > stopping/starting of any services or will it just take the changes on
> > the fly?
> >
> > Thanks, Erick
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-voip
> >
>