[cisco-voip] Carrier Authorization Code

[Kent]

I can tell you this does work.  We ran rightfax with ld codes via a 6608 
blade for several years.  We turned off the ld codes about a year ago, 
as they were just too much of a pain... So I can't even look at the 
config anymore to pass it along.

Also rememer that CCM4+ has ld codes  built in, not worth the expense to 
use a carrier now, but thats my .0000000002 cents

Joel Perez wrote:
> Here is a new one for me guys, hopefully you can help out.
> As im sure some of you guys might remember I just recently installed a 
> RightFax solution for a customer.
> All is going well with that up to now. I just received an email from 
> the customer that they are going to introduce "Carrier Access Codes" 
> for all LD calls.
> Now, I know all about FAC's and CMC's and such and those are a breeze 
> usually.. But in this case once you dial an LD # the carrier prompts 
> you for an access code so you have to enter it manually.
> In Right fax i can set up the same Access codes, but since my right 
> fax server has a PRI to my MGCP GW then it just passes all the digits 
> and doesnt give a chance for the carrier to prompt you for the Access 
> Code. I have tried to insert pauses but it isnt working.
> Has anyone run into a similar situation?
>  
> Thanks,
>  
> Joel P
>  
> ------------------------------------------------------------------------
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip