[cisco-voip] BRI Layer 1 stays deactivated

[Louis Koekemoer (ZA)]

Hi

 

I have arrived on a site with a new gateway with 2 new VIC2-2BRI-NT/TE
that was already installed in the gateway by cisco. I have done my
config the same way I always do, but the interfaces stay L1 deactivated.
And now, they are not shut. I even tried a loopback cable with pin 3&4
and 5&6. This should give me something, and still. Could it be that I'm
doing something wrong here? Here iis my BRI sample.

 

interface BRI0/1/1

 description Connection to PSTN

 no ip address

 isdn switch-type basic-net3

 isdn point-to-point-setup

 isdn incoming-voice voice

 isdn send-alerting

 isdn sending-complete

 

Regards,

Louis


This email and all contents are subject to the following disclaimer:

"http://www.dimensiondata.com/emaildisclaimer.htm"
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20080122/6fae89ab/attachment.html