[cisco-voip] PRI Issue

[Turpin, Mark]

It doesn't look like you've got the physical interface up.  Might want to start with the wiring.


--

MARK TURPIN  |  Systems Engineer  |  CCIE 21649 |  Calence / Insight Networking Solutions  | www.calence.com  
t. 314.656.2315   c. 314.660.5800   f. 314.656.2355   mark.turpin at calence.com
 
The information contained in this message and any attachment may contain privileged or confidential information protected from disclosure. If you are not the intended recipient, or an employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any review, dissemination, distribution or copying of this information is strictly prohibited.  If you have received this transmission in error, please notify the sender immediately by replying to this message and destroying the original and all copies.  Thank you.


-----Original Message-----
From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Steven Sarte
Sent: Tuesday, November 18, 2008 12:54 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] PRI Issue

I'm bringing up a PRI circuit remotely and having issues bringing it
up.  I called the Telco and they said they have no issues on my end.
They claim it is a signaling issue, they are getting this error "Out
of service block.  No response. Auto"  .

I did research on Receiver is getting AIS which says that the issue is
on the Telco side.   But they say they have no issues on their end.

T1 0/0/0 is down.
  Applique type is Channelized T1
  Cablelength is long 0db
  Transmitter is sending remote alarm.
  Receiver is getting AIS.
  alarm-trigger is not set
  Soaking time: 3, Clearance time: 10
  AIS State:Clear  LOS State:Clear  LOF State:Clear
  Version info Firmware: 20071011, FPGA: 13, spm_count = 0
  Framing is ESF, Line Code is B8ZS, Clock Source is Line.
  CRC Threshold is 320. Reported from firmware  is 320.
  Data in current interval (126 seconds elapsed):
     0 Line Code Violations, 0 Path Code Violations
     1 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 125 Unavail Secs

USSTFVG01#show isdn status
Global ISDN Switchtype = primary-ni
ISDN Serial0/0/0:23 interface
        dsl 0, interface ISDN Switchtype = primary-ni
    Layer 1 Status:
        DEACTIVATED
    Layer 2 Status:
        TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED
    Layer 3 Status:
        0 Active Layer 3 Call(s)
    Active dsl 0 CCBs = 0
    The Free Channel Mask:  0x00000000
    Number of L2 Discards = 0, L2 Session ID = 1
    Total Allocated ISDN CCBs = 0


Thanks,
Steven Sarte
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip