[cisco-voip] Adding resources to an MRG: When do they become active?

[Jason Burns]

Is the DevicePool / Region config in CallManager ok for the newly added
xcoder?

Does "show sccp all" show that it has the right codecs advertised and the
right number of sessions?

Have you tried doing "no sccp" then "sccp" on the new transcoder just to
make it register again?

As long as you reset from the MRGL you should start using the new xcoder
device if everything is configured properly. If it's in the same MRG as the
other devices it will get round robined.

To figure out why it isn't working might require looking at some CallManager
traces after double checking all the config.

On Thu, Oct 30, 2008 at 3:16 PM, Dave Wolgast <dwolgas1 at rochester.rr.com>wrote:

> I added an additional transcoding resource to an existing MRG (that already
> contains two XCoders).  Following that, I reset all devices with MRGLs that
> used the MRG.
>
> The two existing XCoder resources are properly round-robining calls, but
> the additional resource hasn't been touched.
>
> I have verified the config on the IOS device and in CUCM (the xcoder is
> registered, and looks OK in IOS, config similar to the ones I have working).
>
> What has to happen for an MRG to start using a new resource?  Is there a
> service restart required?
>
> --
> Dave Wolgast
> Livonia, NY
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20081030/5302d984/attachment.html>