[cisco-voip] Load Balance between SIP dial-peers

[Ali El Moussaoui]

that would be gr8. Thanks Erick.

On Thu, Dec 10, 2009 at 9:06 AM, Erick Bergquist <erickbee at gmail.com> wrote:

> You can do this for outbound calls using dial-peers, need to adjust the
> global dial-peer hunt method. I've done it awhile ago for someone who had
> SIP IVRs and wanted to load balance the calls between them.
>
> I can dig up the dial-peer config stuff if needed.
>
>
> On Thu, Dec 10, 2009 at 12:53 AM, Ali El Moussaoui <mousawi.ali at gmail.com>wrote:
>
>> Its one router connected to 2 different targets and i think what Mark
>> mentioned is true.
>>
>>
>> On Wed, Dec 9, 2009 at 7:03 PM, Hussam Ahmad <hahmad at sigma-it.net> wrote:
>>
>>>  OK, could you please describe the topology?
>>>
>>> do you have two routers with two links in-between or one router connected
>>> to two routers?
>>>
>>>
>>>
>>> Thanks and best regards,
>>>
>>> * *
>>>
>>> *H**USSAM** **A**HMAD***
>>>
>>> Cisco Instructor | Sigma IT – Saudi Arabia
>>>
>>> [image: LOGO6.png]
>>>
>>> Olaya St., Akaria 3, Entrance 13, 5th Floor, Office 509 | Riyadh | KSA
>>>
>>> Tel: +966-1-2150100
>>>
>>> Fax: +966-1-2151090
>>>
>>> Mobile: +966-55-3266244
>>>
>>> Email: hahmad at sigma-it.net
>>>
>>> Website: www.sigma-it.net
>>>
>>>
>>> ------------------------------------------------------------------------------------------------------
>>>
>>> This e-mail communication and any attachments thereto contain information
>>> which is confidential and are intended only for the use of the individuals
>>> or entities named above. If you are not the intended recipient, you are
>>> hereby notified that any disclosure, copying, distribution or the taking any
>>> action in reliance on the contents of these documents is strictly prohibited
>>> and may be illegal. Please notify us of your receipt of this e-mail in error
>>> and delete the e-mail and any copies of it
>>>
>>>
>>>
>>>
>>>
>>> *From:* Mark Holloway [mailto:mh at markholloway.com]
>>> *Sent:* Wednesday, December 09, 2009 7:57 PM
>>> *To:* Hussam Ahmad
>>> *Cc:* 'Ali El Moussaoui'; cisco-voip at puck.nether.net
>>>
>>> *Subject:* Re: [cisco-voip] Load Balance between SIP dial-peers
>>>
>>>
>>>
>>> Are you sure about that?  The expected behavior when creating two dial
>>> peers with identical destination patterns but different session targets is
>>> the lowest numbered dial peer is always used first and if the session target
>>> is not available the next dial peer is used.  Although this does provided
>>> redundancy it's not load balancing.
>>>
>>>
>>>
>>> On Dec 9, 2009, at 1:46 AM, Hussam Ahmad wrote:
>>>
>>>
>>>
>>>   Configure the dial-peers without any preference and it will work as
>>> you want if the destination-pattern is the same.
>>>
>>> Make it and use debug voice dial-peer in to verify it.
>>>
>>>
>>>
>>> Waiting for your reply.
>>>
>>>
>>>
>>> Thanks and best regards,
>>>
>>> * *
>>>
>>> *H**USSAM** **A**HMAD*
>>>
>>>
>>>
>>>
>>>
>>>
>>>
>>> *From:* Ali El Moussaoui [mailto:mousawi.ali at gmail.com]
>>> *Sent:* Wednesday, December 09, 2009 11:43 AM
>>> *To:* Hussam Ahmad
>>> *Cc:* cisco-voip at puck.nether.net
>>> *Subject:* Re: [cisco-voip] Load Balance between SIP dial-peers
>>>
>>>
>>>
>>> they have different session targets
>>>
>>> On Wed, Dec 9, 2009 at 10:21 AM, Hussam Ahmad <hahmad at sigma-it.net>
>>> wrote:
>>>
>>> You can but why do you need it, because how the first dial-peer will go
>>> down.
>>>
>>>
>>>
>>> Thanks and best regards,
>>>
>>> * *
>>>
>>> *H**USSAM** **A**HMAD*
>>>
>>> Cisco Instructor | Sigma IT – Saudi Arabia
>>>
>>> <image001.png>
>>>
>>> Olaya St., Akaria 3, Entrance 13, 5th Floor, Office 509 | Riyadh | KSA
>>>
>>> Tel: +966-1-2150100
>>>
>>> Fax: +966-1-2151090
>>>
>>> Mobile: +966-55-3266244
>>>
>>> Email: hahmad at sigma-it.net
>>>
>>> Website: www.sigma-it.net
>>>
>>>
>>> ------------------------------------------------------------------------------------------------------
>>>
>>> This e-mail communication and any attachments thereto contain information
>>> which is confidential and are intended only for the use of the individuals
>>> or entities named above. If you are not the intended recipient, you are
>>> hereby notified that any disclosure, copying, distribution or the taking any
>>> action in reliance on the contents of these documents is strictly prohibited
>>> and may be illegal. Please notify us of your receipt of this e-mail in error
>>> and delete the e-mail and any copies of it
>>>
>>>
>>>
>>>
>>>
>>> *From:* Ali El Moussaoui [mailto:mousawi.ali at gmail.com]
>>> *Sent:* Wednesday, December 09, 2009 11:18 AM
>>> *To:* cisco-voip at puck.nether.net
>>> *Subject:* [cisco-voip] Load Balance between SIP dial-peers
>>>
>>>
>>>
>>> Hello Guys,
>>>
>>> Is it possible to Load balance between 2 sip dial-peers ?
>>>
>>> Ali
>>>
>>>
>>>
>>> _______________________________________________
>>> cisco-voip mailing list
>>> cisco-voip at puck.nether.net
>>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>>
>>>
>>>
>>
>>
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091210/d87273ec/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/png
Size: 11742 bytes
Desc: not available
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091210/d87273ec/attachment.png>