[cisco-voip] CSIM Start Command

[John Huston]

This looks like a good link.  Thank you for passing it along.

John

--- On Tue, 12/29/09, Turpin, Mark <mark.turpin at Calence.com> wrote:

From: Turpin, Mark <mark.turpin at Calence.com>
Subject: RE: [cisco-voip] CSIM Start Command
To: "John Huston" <fentonguy2003 at yahoo.com>, cisco-voip at puck.nether.net
Date: Tuesday, December 29, 2009, 3:49 PM




 
 






There is a disconnect cause code that should lend insight. 

   

You should couple the command with helpful debugs like ‘debug
voip dialpeer all’ 

   

The following may be helpful as well: 

http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a0080094045.shtml 

   

hth, 

-mark 

   

--



MARK TURPIN  |  SE  |  CCIE
21649 |  Insight Networking | www.insight.com 

Single Number Reach: +1-314-656-2315  mark.turpin at insight.com  

  

The information contained in this
message and any attachment may contain privileged or confidential information
protected from disclosure. If you are not the intended recipient, or an
employee or agent responsible for delivering this message to the intended
recipient, you are hereby notified that any review, dissemination, distribution
or copying of this information is strictly prohibited.  If you have
received this transmission in error, please notify the sender immediately by
replying to this message and destroying the original and all copies. 
Thank you. 

   



From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of John Huston

Sent: Tuesday, December 29, 2009 3:05 PM

To: cisco-voip at puck.nether.net

Subject: [cisco-voip] CSIM Start Command 



   


 
  
  How do you tell if  you
  have a successful call or not using the CSIM Start <Number> command?

  

   
  
 


   



 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091229/cb395930/attachment.html>