[cisco-voip] FXS on 2811 problem

Paul asobihoudai at yahoo.com
Tue Feb 3 09:53:06 EST 2009


Don't you mean a VIC-4FXS/DID card? I don't remember there being a VIC-4FXS card on the market. I'm assuming this is true, thus I'd try reseating the card in a different available slot and then rebooting. I've had this issue in a 3845 and it worked after moving to another slot.

Cheers,
Paul



________________________________
From: Ilya Rubinchik <ilya.rubinchik at abrisdc.com>
To: "cisco-voip at puck.nether.net" <cisco-voip at puck.nether.net>
Sent: Tuesday, February 3, 2009 1:35:40 AM
Subject: [cisco-voip] FXS on 2811 problem


Hi, all!
 
Please help me investigate stramge problem, I’m VERY confused.
 
I have a strange problem on few VIC-4FXS cards installed in
2811 onboard HWIC slots.
FXS ports simple don’t working. PVDM resources is enough,
ports apperaring in configuration, but does not detects connected phone(there
is no dialtone) and ‘debug vpm signal’ shows no activity.
Amber led is lights on all ports.  The same VIC card works just
fine in 3825.
I have tried different IOS version and feature sets, but
with no luck.
 
Right after reboot port’s states is Dormant, UP. 
After shut/no shut ports are stucks in ‘Admin UP’ but ‘Operation
down’ state.
 
Additionally strange S_OPEN_PEND state appearing on these
ports in ‘sh voice call sum’ output.
This is LAB setup, I have no specific wiring and I’m using
regular Panasonic desktop phone.
 
Router has no specific configuration, all voice-port clauses
are empty.
 
 
Here is debugs:
 
fxs#sh voice call sum
PORT           CODEC     VAD VTSP STATE            VPM STATE
============== ========= === ====================
======================
0/2/0         -          -  -                    
S_OPEN_PEND              
0/2/1         -          -  -                    
S_OPEN_PEND              
0/2/2         -          -  -                    
S_OPEN_PEND              
0/2/3         -          -  -                    
S_OPEN_PEND              
 
fxs#sh voice port sum
                                          IN       OUT
PORT           CH   SIG-TYPE   ADMIN OPER STATUS   STATUS  
EC
============== == ============ ===== ==== ======== ========
==
0/2/0          --  fxs-ls      up    down on-hook  idle    
y 
0/2/1          --  fxs-ls      up    dorm on-hook  idle    
y 
0/2/2          --  fxs-ls      up    dorm on-hook  idle    
y 
0/2/3          --  fxs-ls      up    dorm on-hook  idle    
y
 
fxs#sh voice port 0/2/0
 
Foreign Exchange Station 0/2/0 Slot is 0, Sub-unit is 2,
Port is 0
 Type of VoicePort is FXS  VIC-4DID
 Operation State is DOWN
 Administrative State is UP
 The Last Interface Down Failure Cause is Administrative
Shutdown
 Description is not set
 Noise Regeneration is enabled
 Non Linear Processing is enabled
 Non Linear Mute is disabled
 Non Linear Threshold is -21 dB
 Music On Hold Threshold is Set to -38 dBm
 In Gain is Set to 0 dB
 Out Attenuation is Set to 3 dB
 Echo Cancellation is enabled
 Echo Cancellation NLP mute is disabled
 Echo Cancellation NLP threshold is -21 dB
 Echo Cancel Coverage is set to 64 ms
 Echo Cancel worst case ERL is set to 6 dB
 Playout-delay Mode is set to adaptive
 Playout-delay Nominal is set to 60 ms
 Playout-delay Maximum is set to 250 ms
 Playout-delay Minimum mode is set to default, value 40 ms 
 Playout-delay Fax is set to 300 ms
 Connection Mode is normal
 Connection Number is not set
 Initial Time Out is set to 10 s
 Interdigit Time Out is set to 10 s
 Call Disconnect Time Out is set to 60 s
 Supervisory Disconnect Time Out is set to 750 ms
 Ringing Time Out is set to 180 s
 Wait Release Time Out is set to 30 s
 Companding Type is u-law
 Region Tone is set for US
 
 Analog Info Follows:
 Currently processing none
 Maintenance Mode Set to None (not in mtc mode)
 Number of signaling protocol errors are 0
 Impedance is set to 600r Ohm
 Station name None, Station number None
 Translation profile (Incoming): 
 Translation profile (Outgoing): 
 
 Voice card specific Info Follows:
 Signal Type is loopStart
 Ring Frequency is 25 Hz
 Hook Status is On Hook
 Ring Active Status is inactive
 Ring Ground Status is inactive
 Tip Ground Status is inactive
 Digit Duration Timing is set to 100 ms
 InterDigit Duration Timing is set to 100 ms
 Hookflash-in Timing is set to max=1000 ms, min=150 ms
 Hookflash-out Timing is set to 400 ms
 No disconnect acknowledge
 Ring Cadence is defined by CPTone Selection
 Ring Cadence are [20 40] * 100 msec
 Ringer Equivalence Number is set to 1
fxs#sh voice port 0/2/1
 
Foreign Exchange Station 0/2/1 Slot is 0, Sub-unit is 2,
Port is 1
 Type of VoicePort is FXS  VIC-4DID
 Operation State is DORMANT
 Administrative State is UP
 No Interface Down Failure
 Description is not set
 Noise Regeneration is enabled
 Non Linear Processing is enabled
 Non Linear Mute is disabled
 Non Linear Threshold is -21 dB
 Music On Hold Threshold is Set to -38 dBm
 In Gain is Set to 0 dB
 Out Attenuation is Set to 3 dB
 Echo Cancellation is enabled
 Echo Cancellation NLP mute is disabled
 Echo Cancellation NLP threshold is -21 dB
 Echo Cancel Coverage is set to 64 ms
 Echo Cancel worst case ERL is set to 6 dB
 Playout-delay Mode is set to adaptive
 Playout-delay Nominal is set to 60 ms
 Playout-delay Maximum is set to 250 ms
 Playout-delay Minimum mode is set to default, value 40 ms 
 Playout-delay Fax is set to 300 ms
 Connection Mode is normal
 Connection Number is not set
 Initial Time Out is set to 10 s
 Interdigit Time Out is set to 10 s
 Call Disconnect Time Out is set to 60 s
 Supervisory Disconnect Time Out is set to 750 ms
 Ringing Time Out is set to 180 s
 Wait Release Time Out is set to 30 s
 Companding Type is u-law
 Region Tone is set for US
 
 Analog Info Follows:
 Currently processing none
 Maintenance Mode Set to None (not in mtc mode)
 Number of signaling protocol errors are 0
 Impedance is set to 600r Ohm
 Station name None, Station number None
 Translation profile (Incoming): 
 Translation profile (Outgoing): 
 
 Voice card specific Info Follows:
 Signal Type is loopStart
 Ring Frequency is 25 Hz
 Hook Status is On Hook
 Ring Active Status is inactive
 Ring Ground Status is inactive
 Tip Ground Status is inactive
 Digit Duration Timing is set to 100 ms
 InterDigit Duration Timing is set to 100 ms
 Hookflash-in Timing is set to max=1000 ms, min=150 ms
 Hookflash-out Timing is set to 400 ms
 No disconnect acknowledge
 Ring Cadence is defined by CPTone Selection
 Ring Cadence are [20 40] * 100 msec
 Ringer Equivalence Number is set to 1
 
 
Kind regards, 
 
--
Ilya Rubinchik
Systems Engineer
Telecommunication Systems Division
ABRIS DISTRIBUTION, INC. 
Tel: UZ: +998711405300 (ext. 2451)
Mobile: UZ: +998977128456
Fax: UZ: +998712995155
ICQ # 15508236
MSN: ilya.rubinchik at gmail.com
E-mail: ilya.rubinchik at abrisdc.com


      



More information about the cisco-voip mailing list