[cisco-voip] controller errors?

[Tim Smith]

Its not normal, most E1 / T1 circuits should be clean majority of the time.
Something I always check after commissioning circuits.

Cheers,

Tim.

On Thu, Nov 5, 2009 at 8:54 AM, Charles Goldsmith <wokka at justfamily.org>wrote:

> I see this on all of my PRI's that use a T1-crossover cable.  I've
> remade the cables several times but get the same thing on all of them
> (3 connections).
>
> This is on VWIC-2MFT-T1 modules in different routers.  The routers are
> 2821 and 3845s.
>
> I haven't seen this cause any problems, so I didn't pursue it.
>
> I know this doesn't answer your question, but I don't think its out of
> the ordinary, but I could be wrong on that.
>
> Charles
>
> On Wed, Nov 4, 2009 at 3:37 PM, Scott Voll <svoll.voip at gmail.com> wrote:
> > Good Afternoon--
> > I'm getting slip seconds and errored seconds on my PRI controller.
> > about 2-10 per 15 minutes with a total of about 200 per 24 hours.
> > telco says they don't see anything in testing.
> > Is this a hardware issue on the VGW or a Telco problem and I need to tell
> > them to dispatch out and test?
> > Can someone give me a little advise?
> > Thanks
> > Scott
> > H323 2851 running 12.4.24T1
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-voip
> >
> >
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>



-- 

Cheers,

Tim


Sent from Sydney, Nsw, Australia
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091105/97da1095/attachment.html>