[cisco-voip] VWIC2-2MFT-T1/E1 for non-voice data ?

[Matthew Loraditch]

controller T1 0/0/0
channel-group 0 timeslots 1-24

Configure the controllers as such. You will then get serial0/0/0:0 and that acts just like a regular data only t1


Matthew Loraditch
1965 Greenspring Drive
Timonium, MD 21093
support at heliontechnologies.com<mailto:support at heliontechnologies.com>
(p) (410) 252-8830
(F) (443) 541-1593

Visit us at www.heliontechnologies.com<http://www.heliontechnologies.com>
Support Issue? Email support at heliontechnologies.com<mailto:support at heliontechnologies.com> for fast assistance!

From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Scott Voll
Sent: Thursday, November 19, 2009 11:23 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] VWIC2-2MFT-T1/E1 for non-voice data ?

Can I use a VWIC2-2MFT-T1/E1 for just a point to point data T1?

if so, how do I get the serial interfaces setup?  I can add card type, but then I get a controller T1 like it's a voice PRI not a regular t1 data interface serial x/x/x

Thanks

Scott
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091119/66b0b482/attachment.html>