[cisco-voip] dtmf from cucm to 2821 cube to sip trunk

[Dane Newman]

Hmm that does not sound good

This is with the default settings

rtp payload-type nte 101
rtp payload-type nse 100

which don't show up in the config.  Could there be any reason why the router
is not able to use 101 below are my dial peers

dial-peer voice 100 voip
 description AA Publisher
 preference 1
 destination-pattern 1..
 voice-class h323 50
 session target ipv4:10.1.80.10
 dtmf-relay h245-alphanumeric
 codec g711ulaw
 no vad
!
dial-peer voice 1000 voip
 description incoming Call
 translation-profile incoming aa
 preference 1

 incoming called-number 6784442454

 dtmf-relay rtp-nte
 codec g711ulaw
 ip qos dscp cs5 media
 ip qos dscp cs5 signaling
 no vad
!
dial-peer voice 101 voip
 description AA Subscriber
 preference 2
 destination-pattern 1..
 voice-class h323 50
 session target ipv4:10.1.80.11
 dtmf-relay h245-alphanumeric
 codec g711ulaw
 no vad
!
dial-peer voice 2000 voip
 description outbound
 translation-profile outgoing addone
 preference 1
 destination-pattern .T

 progress_ind setup enable 3
 progress_ind progress enable 8
 session protocol sipv2
 session target dns:did.voip.les.net

 dtmf-relay rtp-nte
 codec g711ulaw

!
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091027/0d809b65/attachment.html>