[cisco-voip] FW: D channel out of service (addendum)

[Dennis Heim]

I would double check your clocking..

Do you have other PRI's in this gateway?

What do you have for your network-clock-select and network-clock-participate commands?

Dennis Heim
Network Voice Engineer
CDW  Advanced Technology Services
11711 N. Meridian Street, Suite 225
Carmel, IN  46032

317.569.4255 Office
317.569.4201 Fax
317.694.6070 Cell
dennis.heim at cdw.com<mailto:dennis.heim at cdw.com>
www.berbee.com<http://www.berbee.com/>

From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jeff Ruttman
Sent: Thursday, February 11, 2010 10:20 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] FW: D channel out of service (addendum)

Outbound calls also don't work.  I forgot I had them going out an alternate site's PRI.

Doing a sho controller shows all kinds of errors:  line code violations, slips, errored secs, bursty err secs, etc.  Log shows  the serial interface 0/0/0:23 up but all the serial 0/0/0:1 - 22 to be down.  This was after I reset the GW the morning.

Sound like a telco problem?  I have ticket in.

Thanks
jef

________________________________
From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jeff Ruttman
Sent: Thursday, February 11, 2010 8:28 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] D channel out of service
Greetings,

We have a site with a PRI and we have MGCP gateways configured.  Inbound calls give a slow busy.  Outbound calls are OK.  Interface is up up.  GW is registered.  After a shut no shut on the port and GW reset, port comes up and GW registers just fine.  Then I get an RTMT  Mgcp D channel out of service.

I'm thinking this is a telco problem?  Is there anything I should be doing on my end?

Thanks
jeff
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100211/e207ce7f/attachment.html>